Streamdeck SD+ profile for the FlightFX MG Honda Jet (HJET)
Please read the included manual ( FlightFX_MG_HondaJet_SD+_manual.pdf ) for further instructions and important informations on how to setup the jet to work properly with the SD+ profile.
ATTENTION:
You need the AAO / Axis and Oh's software and the AAO plugin for Streamdeck
Please remove any old version of this streamdeck profile before installing a new version.
Install the SD+ Streamdeck profile by double click on the HondaJet.streamDeckProfile file.
The following functions are coverd in the profile:
"Start" Page for bringing the jet out of cold & dark actions for:
- Battery on/off
- External power on/off
- Left engine start (please remember to put the throttle into idle)
- Right engine start (please remember to put the throttle into idle)
- GPU Support on/off
- Set baro and switch to STD or back
"COM" Page actions for:
- Transponder status
- Vatsim Unicom 122.800 preselect for COM1 standby
- direct link to Autopilot page
- COM1 active/standby frequency info and xfer
- COM1 standby MHz change via rotary
- COM1 kHz change via rotary
- Map/checklist zoom/select/activation via rotary
"Autopilot" Page Actions for:
- AP on/off
- Auto thrust on/off
- Auto thrust FMS/MAN mode
- FLC mode on/off
- HDG mode on/off
- NAV mode on/off
- VNV mode on/off
- ALT hold on/off
- HDG change rotary with sync feature
- Speed change rotary
- Altimeter change rotary with sync feature
- VS rate change up/down with activation feature rotary
"GTC" Page:
This page simulates the GTC knob on the left GTC. Please read more informations in the manual!
- switch active pane on PFD/MFD to the next one left
- switch active pane on PFD/MFD to the next one right
- cursor up/down/left/right
- Zoom/select via rotary knob
- Set baro and switch to STD or back
"Exterior" Page actions for:
- Cabin door open/close
- front cargo door open/close
- rear cargo door open/close
- Covers on/off
I still have some things to implement and I also have to refine the graphics. But I thought you might want to give it a try. Please report bugs and ideas and positiv feedback via comments. Thank you and happy flying.
rwilson142
Maybe you can help with getting the checklist scrolling and activation on a rotary.
Been trying to use "H:gauges_ha420_sys_Checklist_scoll_down" and "H:gauges_ha420_sys_Checklist_enter"
but cant seem to get them to work. I'd like to put it on your start page.
thanks again.
you can DM me if you'd like
Ron
plcarloos
isiFlying author
1 months ago
13.Uniform
isiFlying author
5 months ago